Safety Instructions

WARNING
Danger of death and material damage caused by incorrect installation!
  • ▶Have the installation carried out only by qualified personnel that have been instructed by BST service staff or authorized personnel.
DANGER
Danger of death caused by the machine starting up!

Parts of your body could be crushed, cut, drawn in or hit.

  • ▶Switch off the machine completely and secure it against it being switched back on.
NOTICE
Damage to the system from drilling dust and loose parts!

Drilling dust, splitter and loose parts may damage the machine.

  • ▶Before carrying out drilling or installation work, cover the affected area of the machine with film or paper.
  • ▶After installation work, check that the bolts are screwed tight.
NOTICE
Damage caused by moving the sensor slides by hand!

Moving the sensor slides by hand may lead to damage to the sensor slides.

  • ▶Do not move the sensor slides by hand.

Before starting with the installation work

  • ▶Read the safety instructions in the operating instructions of the machine in which the BST components are to be installed.
  • ▶Observe the complete safety concept of the machine.
  • ▶Cordon-off the work area in order to prevent access by unauthorized persons (e.g. by setting up barriers).
  • ▶Make sure that all parts of the machine where the BST components have to be installed have a sufficient load bearing capacity.

During installation work

  • ▶Observe all safety instructions and hazard warnings on the BST components and the machine.
  • ▶Do not deactivate or remove any protection and safety equipment belonging to the machine. If the protection and safety equipment has to be removed for the installation of the BST components, these must be re-installed immediately after completing the installation work.
  • ▶Escape routes and access to safety equipment must not be blocked by the installation of BST components.
  • ▶Make sure that no parts (e.g. screws, washers, tools) can fall into the machine. Cover the affected area of the machine with film or paper. Parts falling down may damage the machine.
  • ▶Do not climb onto or walk on BST components or unsuitable parts of the machine.
  • ▶Ensure that there is sufficient free headroom. If the free headroom is restricted, the relevant components causing the height restrictions must be padded and danger-warning signs must be attached to them (yellow / black).

After completing the installation work

  • ▶Install all safety equipment and protective covers that had to be removed for the installation work.
  • ▶Check that the bolts are screwed tight.
  • ▶Remove all tools and auxiliary aids used from the machine.
  • ▶Before commissioning, remove any transport locks present from the BST components.