1. Operating Manual
2. Operation
3. Special Guiding and Monitoring Functions
4. Overlaid Web Edge/Web Center-Line Guiding with CLS CAM 100 Object Sensor

Requirements

The following requirements must be fulfilled for operating the overlaid web edge/web center-line guiding with the CLS CAM 100 object sensor:

• Firmware version of the controller ≥ 2.3.2
• Firmware version of the ekr commander control panel ≥ 1.8.1
• A CLS CAM 100 object sensor is connected to the controller.
• The offset control mode is set on the CLS CAM 100 object sensor. For setting the control mode, see installation and operating manual Object sensor CLS CAM 100, document number MD.577.
• One or two edge sensors for web edge or web center-line guiding are connected to the controller.
• The edge sensors are arranged at the same height or behind the object sensor in the web running direction.