Switching On the Overlaid Web Edge/Web Center-Line Guiding

WARNING
Danger of death from actuator movements!

Parts of your body could be crushed, cut or hit.

  • ▶Make sure that no persons remain in the vicinity of the pivot / traversing area of machine components that are positioned by the actuator.
  • »The web edge guiding or web center-line guiding is selected as guiding mode.
  1. Position the CLS CAM 100 object sensor on the print feature.

  1. Press the Sensor 3 key on the controller.
  • The LED of the key illuminates.
  • The feature guiding is activated.

  1. Press the Automatic key on the controller.
  • The LED of the key illuminates.
  • The controller switches to automatic mode.
  1. Move the web to the desired guiding setpoint (by moving the CLS CAM 100 object sensor mechanically across the web running direction).

  1. Position the edge sensors so that the web edges are located in the centre of the sensor scanning areas.
  • The current position of the web edge in the sensor scanning area is shown in the display of the controller under the respective sensor symbol.

  1. Press the Sensor 3 key on the controller and keep it pressed.
  • The LED of the key illuminates.

  1. When using the web edge guiding mode, press the key of the edge sensor used (Sensor 1 or Sensor 2).

  • When using the web center-line guiding mode, press the Sensor 1 and Sensor 2 keys at the same time.
  1. First release the Sensor 3 key and then the keys of the edge sensors used (with web edge guiding key Sensor 1 or Sensor 2, with web center-line guiding keys Sensor 1 and Sensor 2).
  • Caution! Observe the order in all cases!
  • The LEDs of the edge sensors used illuminate.
  • The overlaid web edge/web center-line guiding is switched on.