Intended Use
The system is only determined for web guiding.It permits guiding according to the web edges, web center-line, printed lines or contrast edges.
The system is installed in a machine or assembled together to form a machine with another machine in compliance with the Machinery Directive 2006/42/EC. All machines of the entire system must comply with the guidelines of the Machinery Directive after being installed in the system.
The system and all of its components are only intended for use in industrial environments.
The system may only be put into operation if the following guidelines are also complied with:
- The product must only be installed or operated in a non-explosive atmosphere.
- The product and all components must only be used in a perfect technical condition.
- All technical safety equipment must be in a perfect technical condition.
- The product must only be operated using the components that belong to the system. An exception are such third party components that have been supplied by BST eltromat International or have been explicitly approved for being operated with the system.
- Any part found to be working incorrectly must be replaced using original spare parts immediately.
- All work on or with the product must only be carried out by instructed and qualified personnel, see chapter Qualification of the Personnel.
- These instructions and all safety information must be observed.
- The operating conditions and performance limits specified in the technical specifications must be observed.
