Message Output “System OK“
The controller is equipped with a message output with potential-free changeover contact. In a fault-free state, the message “System OK” is active at the output. If a fault is detected, the relay switches and the message output signalizes that a fault is present in the system.
The message output can, e.g. be used to report faults of the web guiding system to the machine control.
The following faults are output at the message output:
Fault | Fault icon (display screen) |
|---|---|
Supply voltage not present |
|
Limit switch active |
|
Motor overcurrent |
|
Motor control timeout |
|
Supply voltage outside the permissible range |
|
Buffer battery charge status |
|
A description of the individual faults can be found in the operating manual of the ekr CON 600, ekr CON 600 net controller (document number MD.542).
