X100 ... 104 - Connection of CAN Bus Participants
The CAN bus participants (ekr commander control panel, digital edge sensors, additional ekr commander control panel, ...) are connected to the controller using a 4-pin micro-style plug M8.
Rotate the smartphone by 90 degrees to show the entire table.
Contact | Signal | Wire colour | Comments |
|---|---|---|---|
1 | +24 V⎓ output | brown | Leads internally to terminal strip X8 or X9 |
2 | CAN-H | white | |
3 | CAN-GND | green | |
4 | CAN-L | yellow |
