Fault Displays
If a fault or an extraordinary operating state occurs during operation of the web guiding system, this is shown by a symbol in the display. The meaning of the different symbols is described in the following chapters.
For troubleshooting, see Troubleshooting.
Additional information
- Limit Switch Active
- Actuator Blocked (Motor Overcurrent)
- Supply Voltage Outside the Permissible Range
- Motor Control Timeout
- Controller Interlock Active
- Keyboard Interlock Active
- Setup Lock Active
- Bus Connection Fault
- Edge Sensor Malfunction
- Loss of the Line / Contrast Transition
- Loss of the Web Edge (CCD Camera)
- External Motor Output Stage Fault (Drive Module 160)
