Setting the Guiding Direction for Center Positioning

If you use a servo center transducer (OMG 4, OMG 8, CK 37), you have to check the guiding direction for the operating mode Center Positioning.

Checking the guiding direction

WARNING
Danger of death from actuator movements!

During function tests, parts of your body may be crushed, cut or hit.

  • ▶Make sure that no persons remain in the vicinity of the pivot / traversing area of machine components that are positioned by the actuator.
  • ▶
    Press the Center positioning key and observe the guiding device.

  • The guiding device must move into its central position.

If the guiding device moves into one of its end positions then you have to reverse the guiding direction.

Reversing the guiding direction

  • ▶Change DIL switch S4.2 on the processor board of the controller (see Setting DIL Switch S4).