Commissioning
Additional information
- Safety Instructions
- Requirements
- Setting the DIL Switches of the Controller
- Setting the DIL Switches of the Control Panel
- Setting the Jumper
- Checking the Device Addresses
- Setting the Terminating Resistors
- Calling up the Setup Menu
- Setting the Dimension Unit
- Setting the Motor Rotation Direction
- Commissioning the Actuator Without Position Feedback
- Commissioning the Actuator With Position Feedback
- Setting the Guiding Direction
- Performing the Material Setup
- Adjusting the Controller Gain
- Commissioning the CCD Camera
- Commissioning the Sensor Positioner
- Commissioning the Positioning Unit
- Commissioning the Electronic Remote Precision Adjustment (Optional)
- Commissioning the Linear Position Sensor
