If the Automatic setpoint acceptance function is activated, after switching to Automatic operating mode, the sensor positioner carries out an automatic edge detection. In doing so, the sensor slides run towards the web of material until the sensors have detected a web edge. The position of the web edge detected is taken over as the setpoint for guiding.
Activating automatic setpoint acceptance
»The Sensor positioner setting menu is open.
Press the Automatic setpoint acceptance button.
The button is displayed with a blue background.
The function Automatic setpoint acceptance is activated.
Press the SETUP key.
The settings made are saved.
The setup menu is displayed.
If the Automatic setpoint acceptance function is activated, in the lower left corner of the operation display, the button Automatic setpoint acceptance is displayed.
▶To switch the function Automatic setpoint acceptance on / off, press the adjacent button.
When the function is switched on, the button is displayed with a blue background.
