Installing the Controller

NOTICE
Damage to the system from drilling dust and loose parts!

Drilling dust, splitter and loose parts may damage the machine.

  • ▶Before carrying out drilling or installation work, cover the affected area of the machine with film or paper.
  • ▶After installation work, check that the bolts are screwed tight.
Installation of the controller
  1. Make the securing boreholes in the frame of the machine according to the hole template (see Securing Hole Template).
  1. Unscrew the screw of the housing cover ① and then open the cover carefully.
  1. Screw on the housing using two securing screws ② (hexagon socket screws M5) and washers.
  1. Carry out the electric wiring or plug in the required cable connections (see Electrical Connection). Observe the instructions of the correct EMC wiring (see EMC Suitable Wiring)!
  1. Close the housing cover ① and screw it in place.
  1. If necessary, adapt the position of the control panel to the installation position of the controller (see Turning the Control Panel).