Installing the Control Panel

NOTICE
Damage to the system from drilling dust and loose parts!

Drilling dust, splitter and loose parts may damage the machine.

  • ▶Before carrying out drilling or installation work, cover the affected area of the machine with film or paper.
  • ▶After installation work, check that the bolts are screwed tight.
  1. Disconnect the plug ① on the connecting cable ② for the control panel from the controller.

  1. Unscrew the four securing screws ③ of the control panel ④ and store in a safe place. These screws are required for the wall mounting of the control panel.
  1. Pull the control panel ④ off forwards from the controller ⑤. In doing so, pull the connecting cable and the plug ① carefully through the hole ⑥ in the controller housing.

  1. Fit the M3 threads in the holes as shown in the securing hole template (see Securing Hole Template).
  1. Use the four M3 screws ③ to screw the control panel ④ on. The four hexagon socket screws that secured the control panel to the controller when the unit was delivered can be used for this.
  1. Use the optional cable extension to connect up the control panel to the controller (see Cable Extension).
  1. Plug the cable extension plug into socket X100 on the controller.