Controller Device Address

The device address of the controller has been pre-set to 1 in the factory (delivery state).

The device address must only be edited in agreement with the manufacturer!

You can set the device address of the controller using the rotary switch S1 on the processor board.

Rotary switch S1 on the processor board

Checking the device address

NOTICE
Damage to the components from working on live parts.
  • ▶Before opening the controller, switch off the power supply.
  1. Electrically isolate the controller.
  1. Open the controller’s housing cover.

  1. Check the setting of the rotary switch S1 on the processor board. The rotary switch S1 must be set to position 1.
  1. Switch the rotary switch S1 to position 1 if necessary.
  1. Close the controller’s housing cover.