Material Thickness Compensation

This function is no longer available from firmware version 1.9.16 of the ekr commander control panel. In this case, the material thickness compensation is performed on the CCD CAM 100 camera. For the procedure, please refer to the separate installation and operating manual CCD CAM 100, document number MD.465.
DANGER
Danger of death caused by the machine starting up!

Parts of your body could be crushed, cut, drawn in or hit.

  • ▶Switch off the machine completely and secure it against it being switched back on.
  • ▶Carry out the material thickness compensation only when the production machine is stationary.
Additional information