Setting the DIL Switches of the Controller

Before commissioning the web guiding system, you must set the DIL switches on the processor board of the controller according to the application.

NOTICE

Damage to the components from working on live parts.

▶Before opening the controller, switch off the power supply.

You can display the position of the switches on the processor board of the controller using a special service display. The procedure for calling up the service display is described in the operating manual of the ekr CON 600, ekr CON 600 net controller, document number MD.542.

Additional information

DIL Switch Overview
Using the DIL Switches
Setting DIL Switch S4
Setting DIL Switch S5
Setting DIL Switch S6
Setting DIL Switch S7

Additional information

Calling up the Setup Menu