Activating the Normalized Display

You activate the normalized display in the Actuator setting menu.

  1. Activate the Actuator setting menu in the setup menu (see Calling up the Setup Menu).
  • The setting menu for actuators with position feedback appears in the display.

  1. Switch the normalized display on by pressing the adjacent button.

  • An additional input field for the distance of the actuator end positions is displayed below the three buttons for the two software limit switches and the center position.
  1. Enter the distance of the end positions in the input field (190 mm in the example).

  1. Confirm your entry by pressing the button.
  • The setting menu is closed.
  • The setup menu is displayed.

  1. Press the SETUP key to return to the operation display.